Subject: Cheap Simple One barrel carb for slide throttle.
From: rotaryeng
Date: 1/9/2012, 5:10 PM
To: AAAA Put this in the To box


 This is pretty self explanatory.
 To lean the carb you move the entire float
 bowl up and down.

 It is mostly made from Holley stock parts.

 BTW Mark S, if you are building a P-port from scratch
 you could keep one small side port for each rotor
 for the idle system.

 Paul Lamar

      Paul,  It would seem that the slide  would be the throttle plate
 for the
      carburetor and that a similar slide choke plate would eliminate the
 drag
      of the choke plate at WOT.  As for the restriction of the venturi
 making
      the intake diameter effectively smaller you might use a booster venturi
      which is removable on several brands of carburetor and allows intake
        area  around  the outside of the booster.

      George grimes


      Thanks for the suggestions George. Can you make a 3D for me?

      Paul Lamar


 Paul, In the 60's  Chrysler built 413 cu in wedge super stock engines
 with 31 inch long tuned runner between the
 4-barrel carbs and the intake valves.  The carbs were located on the
 opposite side of the engine so as not to affect the tuned length that
 ended at the throttle plates.  If the proposed 1-barrel is close to the
 slide throttle wouldn't the venturi  negate the tuned length runner
 benefit?  I see this as a different condition than the slide throttle
 being in the runner at 75% power cruise HP.  There may be some effect on
 the resonant pulse but only at reduced power. At WOT it is not in the
 runner but the carburetor venturi would always be present..I can
 understand that throttle response on a road racing car is important and
 having the volume below the throttle at a minimum helps the throttle
 response but that is irrelevant on an aircraft engine.
 George grimes

 Yes and that is why I moved it out to the ends of the tubes  in the
 latest iteration. Actually since we have HP to burn it might not bother
 the tunning enough to mater when mounted close to the slide.

 When the carb is near the  input end of the tube you get a lot of fuel
 vapor stand off so one must use a sealed ram airbox. See this You Tube
 video.

 http://www.youtube.com/watch?v=NKJ00JsnS8A

 Paul Lamar


Paul,

There are several version that you have posted.  Could the venturi be located close to the slide throttle?  Why not use one bowl and float with 2 needle valves between the two runners? Reduce parts count.  Is the the slide throttle the throttle plate in the carb scheme?  I need a fuel system soon and always liked the carb for simplicity.

Joe Berki


The reason I went with one float bowl per throat was for capacity
reasons. One Holly float bowl per two throats would be fuel
limited. You get two float bowls with every Holly 4 barrel.

As George pointed out... not a good idea to put the carb
next to the slide. It ruins the tuning to a certain extent.


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.