Subject: Latest one barrel Holley for slide throttle
From: rotaryeng
Date: 1/9/2012, 9:14 AM
To: AAAA Put this in the To box



... this is another of those stupid ideas that pops into my head from
time to time ... ignore me if you start laughing too hard!

But ... could a ball-valve work as an off-the-shelf throttle for your
Holly carb setup?

See the following:
http://images1.mcmaster.com/Contents/gfx/large/2693k22p1l.png?ver=19729922

Hog a couple of pounds of excess metal off the above unit(s) and run
your intakes into it (about $70 each, however).

Might be a bit stiff to operate (at least at first)

R.Berglund

A 2 inch ID brass ball valve would have a serious effect on the CG :)


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.