Here is a housing tube in approx the same length as the Tracy unit.
Perhaps you have the actual length of tracy's housing, I could not find
a length for it.
The photo shows two supports that can be welded around the tube. The
will be placed over the points where the bolts come through the bell to
receive the threads. There are six bolt positions, so six buttress
points. Do you think I should add the long buttresses or the short ones?
Or are they both much too long? The tube is really stiff by itself so
the flange may just need about 2" gusset.
Ed Carver
If the tube goes through the flange and is welded on both side
with good penetration you don't need the ribs. Did you pre heat the
assembly to 500 F before welding? The design is over kill.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.