Subject: Prop housing in the roug
From: rotaryeng
Date: 1/12/2012, 11:12 PM
To: AAAA Put this in the To box



Here is a housing tube in approx the same length as the Tracy unit.
Perhaps you have the actual length of tracy's housing, I could not find
a length for it.

  The photo shows two supports that can be welded around the tube. The
will be placed over the points where the bolts come through the bell to
receive the threads. There are six bolt positions, so six buttress
points. Do you think I should add the long buttresses or the short ones?
Or are they both much too long? The tube is really stiff by itself so
the flange may just need about 2" gusset.

Ed Carver

If the tube goes through the flange and is welded on both side
with good penetration you don't need the ribs. Did you pre heat the
assembly to 500 F before welding? The design is over kill.

Paul Lamar


No preheat. The id of the flange was beveled leaving only 1/8 in the
middle for centering. The weld shrank the id of the drawn tube 0.010".
The weld represents more than 90% of the contact area around the tube.
The flange is 16mm thick.

It remained hotter than hell for more than an hour. My welder was set on
max using .045 wire. I welded it slowly, jumping from side to side until
it was really hot. Then I laid down most of the rest of the wire on the
spool filling the large beveled area. The UV from a weld this hot will
burn your skin in a hurry, and give you a good dose of wonderful Ozone,
as the super bright light reacts with the oxygen in the air for a good 6
feet around the weld area.

I will clean up the weld on the mill with a bullnose cutter. The weld
material is heat treatable. The base metal is 6061 t6. This assem
represents about $30 in material costs, including the weld wire spool.

Ed Carver


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.