Subject: prop shaft bearings and hubs
From: rotaryeng
Date: 1/13/2012, 8:05 AM
To: AAAA Put this in the To box


Did the front wheel bearings on my 2500HD Truck this past weekend.

It is a complete hub assembly, Timken SP580310 -- mind blower is $190,
but I started looking at this assembly and realized it is damn near a
prop bearing assembly. Cable is the ABS speed sensor!

So with a hub, mounting flange (wheel side - 8 x 6.5" bolt pattern), two
heavy bearings,
splined for a drive shaft, and MADE IN USA... $190.

Too heavy for aircraft, but just wanted to present a little thinking
outside of the box.
If I was using a belted drive, it would be one heck of a decent assembly.

What is the common prop size you are targeting? SAE2 (6 bolt)?

Tom Walter

One of the features we use to cut the weight is doing away with the conventional steel SAE prop flange. We are adopting the new Warp Drive, Power Fin, Sensenich adjustable pitch... prop hub standard instead.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.