Subject: Integral prop shaft and planet carrier weight Revised
From: rotaryeng
Date: 1/30/2012, 5:07 AM
To: AAAA Put this in the To box


This looks real simple. It might be easier than I first thought.
Getting the roll pins out with Jean's bigger hammer goes a long way
towards making this viable.

Paul Lamar


 I love your Rhino illustrations.

 Would there be an easy way to show how the sun-gear shaft/bearings fit
 into this. With some sort of vibration/damper/isolation between the
 rotor-shaft and the sun-gear I find myself puzzled as to how everything
 stays where it is supposed to be/

 Robin No name :)


 The same way Tracy does it.

 Paul Lamar


 The weak link so far has been the stock Mazda auto tranny flex plate.
 Ed Carver is working on fixing that as well.

 Paul Lamar

...and the pin holding the sun gear to the input shaft.

Mark

Yes and that too.


Paul Lamar


Thanks for the pics. are you still considering the bellhousing,
or is it to mount on the front cross-member plate?

Graeme Riley


With minor modes it will fit either.

Here are some revised weight savings. The orginal weight estmate was based
on a longer box. I cut the box length down to be the same as Tracy's box.

The prop shaft and planet carrier combined is 3.9 pounds. The current Tracy
shaft prop flange and ball bearing is about 9.2 pounds perhaps a bit less as
Tracy as drilled some holes in the flange. A huge savings as the planet
carrier is not included in Tracy prop shaft. On the other hand the prop
flange is replaced by a large diameter aluminum plate to accommodate the
prop blade pillow blocks.

The housing is 6.6 pounds which is less than the current Tracy 10 pound
version. Not including a large spacer Tracy uses between the housing
and the motor plate.

Input shaft and sun gear is 2.4 pounds.

The ring gear is 4 pounds but almost half of that can be cut off.

Planet gears, needles, shafts and spacers are .5 pound each for a total
of 3 pounds.

Total is 17.9 pounds less the adapter plate and bolts.

The auto tranny bell housing is 8.9 pounds. Total about 26.8 pounds.
Jeff's motor plate motor mount is 6 pounds less spacers and long 8 mm
bolts so that is pretty much a wash but the bell housing has no motor
mounts. Motor mounts can weigh as much as 10 pounds over what is needed
for Jeff's plate.

This box is going to save about 13 pounds over the current design.
That has a large effect on the CG as the box is almost the most further
forward of all masses.

Paul Lamar

Would seem logical to use Jeffs plate for a total of 26.8 lbs + some
hardware.  I'm looking at the RWS RD-1C right now at 44.5lbs.  Tracy
has his sealed bearing secured by a freeze ring and the front cover
plate.  In fact the prop shaft set-up looks like a diff axle.  We
might be able to back the rear bearing onto the planetary, insert the
shaft in the housing, then fit the spacer, front bearing and front
end plate.  This will ease assembly.


What lubrication does the planetary require?

Graeme Riley

Normally auto tranny fluid. I am leaning towards a separate oil supply for the gear box. I suspect the planetary will transfer oil from one side to the other by the action of the helical gears. Perhaps this could be used to circulate the auto tranny fluid through a small low pressure oil cooler.

Paul Lamar


-- 
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.