Paul, I have a courious question.
If I plug the secondary intakes ports and power off the injectors to those intakes,
will the engine run fine with only the primary intakes ports and primary injectors?
I believe it will not deliver all its potential power but could probably run at 2 to
3 thou rpm.......just wondering.
Because if this is true, I will make my engine run on primary only at idle and
taxing. This will probably save some fuel in the long run....
I appreciate your comment. Thanks.
Ramon
I doubt you will notice the fuel savings. The fuel burned during taxi is very little
compared to the hours of flying at 150 HP and up. The complication will not be worth it.
A big problems with side port engines is there are no off the shelf side port
manifolds suitable for aircraft use. You might be very disappointed in the power if
you cobble one up. The best thing to do is a p-port as that is guarantied to give you
250 HP. You don't have to use it all if you don't want but the manifold is cheap and
light weight. You can still use two injectors per rotor and turn one off below 3,000 RPM.
http://www.rotaryeng.net/fund-of-intake.html
http://www.rotaryeng.net/Welded-steel-p-port.html
http://www.rotaryeng.net/slide-throttle.html
Jeff is already set up for doing this at low cost. See the attached jpg's. It will
save you time and money in the long run.
Paul Lamar
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.