Paul,
I have quite a bit of experience running the 13b on natural gas. In fact Mazda
built 13b natural gas engine blocks back in the '90's.
There are still some here in my state still brand new in boxes. I just bought two.
During testing when I worked at RPI the 13b would run 8k -10k on the stock seals.
With ceramic seals the time doubled.
The natural gas engines come with ceramic seals and 9.7 compression.
Another interesting thing about the natural gas engines is they run so clean that
they have omitted the trailing ignition. The rotor housings only have one spark plug
hole. And the oil metering is half of a gasoline 13b. So the engine is equipt with
two spark plug distributor and only two line oil metering.
Back in the day we did a test in the field with the Idaho fish and wildlife for an
indian tribe raising salmon. They needed an engine to pump water from the river into
tanks where they would raise the fish and then put them into the river. The engine
had to run for six week straight. The requirements where no engine pollution, no
noise, and no evidence left behind when job was finished. The team parked the 13b
on a trailer near the stream with a belt drive running a pump. A propane take was
delivered to the area and feed the engine.
The engine had an audible horn and light to tell when it was time to add the oil. A
local indian tribe member parked a small trailer next to the engine trailer and kept
the engine topped off. Worked great.
Maybe you could pass this along to Danny Perterson.
Thanks,Skip Gorman
Who do you get ahold of to buy an engine and how much?
Dale Davies
Thanks for the info Skip,
I was out of pocket for a few days. Like Dale I am curious how I can get ahold of
one or more of these boxed engines. Next question, what
type of reduction unit should be used?
Danny Petersen
Ditto that.
Chris Cosman
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.