Subject: fuel rail and the RX 8 injectors
From: rotaryeng
Date: 6/5/2012, 7:40 PM
To: AAAA Put this in the To box


 Paul,

 I am trying to make the fuel rail and the RX 8 injectors work.
 I have attaché a sketch with fuel rail A and fuel rail B.
 I am using B and want to know what the lower cup style O ring is supposed to do?
 Rail A, and I do not know what the RX 8 uses, might provide a backup with the second
 lower cup style O ring.
 I drilled the AN6 style rail to 27/64ths and countersunk the end to funnel the O
 ring into the bore.
 Looking on the internet, the car guys use vasoline to get the rings to move into the
 bore.
 I do not feel confident in the seal design.

 Appreciate any input.


 Joe Berki
 Limo EZ
 13b P Port

 You only need the one upper O-ring.
 Take the O-ring clip off.
 Don't forget to connect the fuel rail to the intake manifold so the fuel pressure
 does not blow it off.

 Paul Lamar

Paul,
Thanks, does the O ring at the tip of the injector needs to be present in your
injector holder design?  I assume it provides the seal for the injector to runner?

Joe Berki

The O-ring at the tip does not have to be there. There will be slight leak but if you
use manifold air press air leaks don't matter.

Paul Lamar

-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.