Hello,
 I am looking for a rotary engine school, college or course I can attend. I
 am located
 in Virginia, US but will go to where I need to go. Thanks.

 Edgardo

 There are no schools that I know of.

 Read the everything on the  web site below and then ask questions on here.

 Will will be glad to give you an education.

 Paul Lamar

 Hi, i'm driving from Montreal to Florida tomorrow through sunday to work on
 my aircraft for a few weeks, as a thought is there anyone more or less
 along the way with a rotary aircraft project that doesn't mind showing it
 off briefly, maybe answer a few questions i might think of. I know its
 friday tomorrow so most are working, just on the off chance,

 Alex


 Alex,

 I'm in Manchester, CT not too far off I-91 just east of Hartford. (I-91 to
 I-291
 to I-384 exit 2(about 8-10 minutes)). I will be doing some riveting on my
 RV-9A
 this weekend. Send me your email address and cell # to (wmjack at t3cs.net
 )
 and
 we can work something out.

 Regards,

 Jack Hilditch

 Edgardo,
 Some of us on here learned early on in the RX2 days, and the only school
 was
 the "School of Hard Knocks". We broke everything except an eccentric shaft
 learning how to make reliable hp out of these. It's a good thing parts back
 then were really cheap!
 The guys on this forum are some of the best out there in the rotary world
 for aircraft applications. Some of us are opinionated, but the technical
 value of what Paul has on his site is beyond valuable to the new rotary
 fan.
 Have fun!
 Larry

Thanks Kevin & Jack,

Jack i sent you a mail, Kevin i am up between Williston and Daytona, will
see what i can do to drive down to the keys on a weekend

Alex

-- 
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.