Hello,
  I am looking for a rotary engine school, college or course I can attend. I
  am located
  in Virginia, US but will go to where I need to go. Thanks.

  Edgardo

  There are no schools that I know of.

  Read the everything on the  web site below and then ask questions on here.

  We will be glad to give you an education.

  Paul Lamar

  Hi, i'm driving from Montreal to Florida tomorrow through Sunday to work
 on
  my aircraft for a few weeks, as a thought is there anyone more or less
  along the way with a rotary aircraft project that doesn't mind showing it
  off briefly, maybe answer a few questions i might think of. I know its
  Friday tomorrow so most are working, just on the off chance,

  Alex


  Alex,

  I'm in Manchester, CT not too far off I-91 just east of Hartford. (I-91 to
  I-291
  to I-384 exit 2(about 8-10 minutes)). I will be doing some riveting on my
  RV-9A
  this weekend. Send me your email address and cell # to (wmjack at
 t3cs.net
  )
  and
  we can work something out.

  Regards,

  Jack Hilditch

  Edgardo,
  Some of us on here learned early on in the RX2 days, and the only school
  was
  the "School of Hard Knocks". We broke everything except an eccentric shaft
  learning how to make reliable hp out of these. It's a good thing parts
 back
  then were really cheap!
  The guys on this forum are some of the best out there in the rotary world
  for aircraft applications. Some of us are opinionated, but the technical
  value of what Paul has on his site is beyond valuable to the new rotary
  fan.
  Have fun!
  Larry

 Thanks Kevin & Jack,

 Jack i sent you a mail, Kevin i am up between Williston and Daytona, will
 see what i can do to drive down to the keys on a weekend

 Alex

I have an apartment under my house that you can sleep for the night if you
 come down.

 Kevin Alderman

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.