Subject: Cheap turbo compound rotary
From: rotaryeng
Date: 6/30/2012, 12:22 PM
To: AAAA Put this in the To box


 I just had a brilliant idea.

   Unbolt the DD15 turbo
   and blow down turbine and bolt it on a Mazda p-port 3 rotor of
 around 500  HP.

   If you can do that and show a legitimate .39 BSFC on the dyno the world
   will beat a
   path to your door.

   Paul Lamar

  I know you can come up with a quick and dirty turbo compound Paul.
 Don't quit on the idea.  Maybe this is it.

  Van

  I think so. It might not be perfect but it can be optimized after
 the principle is demonstrated.

  Paul Lamar

  Big truck junkyard. I can get a whole older engine for $5K. They
 sell removed parts too.

  Kevin Alderman

  The DD15 has only been around for 3 years or so.

  Paul Lamar

 Steve again

 How sensitive to exhaust back pressure are diesel engines?
 I wonder what order of restriction the Axial Power Turbine would
 introduce and how a rotary will respond? Obviously 13, 20B's have
 been happy with driving a turbo turbine but how do they compare with
 an axial power turbine?

 Steve Izett

 Well here is some old NACA data on the subject of back pressure on
 TC engines. Sorry about the crappy copy but what do you expect from
 government work? I tried to clean it up but it is tedious work.
 -----------------------------------------------------------------

 Here is the complete raw original paper.
 Somewhat easier to read the numbers.

 It looks like the net power continues to increase up to a back
 pressure of 60 inches of Hg.

 Paul Lamar

 Mazda used sequential turbines on both the later 13B and the 20B. The
exchange of one for an axial flow should not change things by much. Still gas
flows through.
 The 20B displacement calculated as per racing is 3.928L. use this and design
RPM to get basic gas flow outside boost. Detroit Diesel makes these engines in
3 displacement sizes; DD13-12.8L, DD15-14.8L and DD16-15.6L.
 The diesel engine operating ranges will be 1200 to 2100 RPM. They will likely
be driving down the road at 1400-1500RPM. The 20B for AC use will run between
6000 and 7500RPM. The RPM difference evens out the displacement difference and
the DD15 components look like a good match. The DD16 turbo may be better for
extended use on the 20B. Max boost may be down, but the turbo may last longer.
The DD13 components may work on a p-port 13B especially with a 3.17 PSRU. Of
course parts availability and cost are to be considered. The DD13 should be a
big seller in the urban delivery market while the DD15 is aimed at the hi-way
truck market. The DD16 will have a more limited appeal to long haul drivers
and more in the Owner/Operator arena.

Dale Davies

I am not sure the smaller DD13 is turbo compound.

Paul Lamar
-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.