Subject: Traditional Megasquirt aircraft problems better
From: rotaryeng
Date: 7/8/2012, 5:55 PM
To: AAAA Put this in the To box



 The Megasquirt was initially rejected for aircraft use as there was no
 method of
 manually leaning it. The other problem was the Megasquirt relies on the O2
 sensor to
 set the mixture. O2 sensors are damaged by 100LL. A third problem was the
 throttle
 position sensor TPS was required.

 As I recall Tracy used these problems years ago as the rational for doing
 his super
 simple system that uses only manifold air temperature MAT/IAT and manifold
 air
 pressure MAP to set the mixture at any RPM. Therein lies part of the
 problem tuning
 Tracy's system.  Some people have taken a year of flying to get it right.

 The last thing was the Megasquirt rotary engine ignition problem. The
 rotary engine
 ignition problem could be solved using extra hard ware and was solved but
 it was a
 messy kludge.

 I agreed with him at the time. That was years (10) before I had the idea
 of using one
 cheap Megasquirt per rotor. One per rotor is likely to eventually simply
 solve the
 ignition problem using off the shelf computer trigger inductive coils like
 the LS1
 and the RX8 coils with out using one CD system per plug. One CD system per
 plug is
 more expensive than a computer triggered inductive coil like the LS1 or
 RX8.

 I know Motorola/FreeScale  68K asm code so in theory I can fix these
 problems by
 recoding the chip.

 Another way of leaning the Megasquirt is trick the MS computer by manually
 adjusting
 the O2 sensor input voltages and simulating the TPS as wide open with
 voltage
 dividing potentiometers.

 Perry Mick does something like that using a stock RX7 computer and
 probably has over
 1000 hours on it.

 The siren song of the Megasquirt was and still is the built in simple
 EFIS, easy
 tuning using a note book computer and data logging.

 Time and new technology and new ideas tend to change old rational.

 Paul Lamar


I've thought about the leaning problem with MS for the past couple years
sense the issue has come up. Seems you could leave out the O2 sensor and
replace it with a pot after the running parameters have been programmed.
Then read your egt for best mix.

Seems we could also modify the injector dwell time similarly. I have a
couple MS2 boxes and will loan you one if you like. I'm all for using two
crank triggers, optical, hall, or whatever for a CD setup.

Ed Carver

Yes! I would like to test them Ed. I can come over and pick them up.

Paul Lamar

-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.