Subject: Traditional Megasquirt aircraft problems better
From: rotaryeng
Date: 7/8/2012, 10:27 PM
To: AAAA Put this in the To box


  The Megasquirt was initially rejected for aircraft use as there was no
  method of
  manually leaning it. The other problem was the Megasquirt relies on the O2
  sensor to
  set the mixture. O2 sensors are damaged by 100LL. A third problem was the
  throttle
  position sensor TPS was required.

  As I recall Tracy used these problems years ago as the rational for doing
  his super
  simple system that uses only manifold air temperature MAT/IAT and manifold
  air
  pressure MAP to set the mixture at any RPM. Therein lies part of the
  problem tuning
  Tracy's system.  Some people have taken a year of flying to get it right.

  The last thing was the Megasquirt rotary engine ignition problem. The
  rotary engine
  ignition problem could be solved using extra hard ware and was solved but
  it was a
  messy kludge.

  I agreed with him at the time. That was years (10) before I had the idea
  of using one
  cheap Megasquirt per rotor. One per rotor is likely to eventually simply
  solve the
  ignition problem using off the shelf computer trigger inductive coils like
  the LS1
  and the RX8 coils with out using one CD system per plug. One CD system per
  plug is
  more expensive than a computer triggered inductive coil like the LS1 or
  RX8.

  I know Motorola/FreeScale  68K asm code so in theory I can fix these
  problems by
  recoding the chip.

  Another way of leaning the Megasquirt is trick the MS computer by manually
  adjusting
  the O2 sensor input voltages and simulating the TPS as wide open with
  voltage
  dividing potentiometers.

  Perry Mick does something like that using a stock RX7 computer and
  probably has over
  1000 hours on it.

  The siren song of the Megasquirt was and still is the built in simple
  EFIS, easy
  tuning using a note book computer and data logging.

  Time and new technology and new ideas tend to change old rational.

  Paul Lamar


 I've thought about the leaning problem with MS for the past couple years
 sense the issue has come up. Seems you could leave out the O2 sensor and
 replace it with a pot after the running parameters have been programmed.
 Then read your egt for best mix.

 Seems we could also modify the injector dwell time similarly. I have a
 couple MS2 boxes and will loan you one if you like. I'm all for using two
 crank triggers, optical, hall, or whatever for a CD setup.

 Ed Carver

 Yes! I would like to test them Ed. I can come over and pick them up.

 Paul Lamar


Any time I guess, give me a heads up the night before.

Ed Carver

OK Ed.

Paul Lamar


-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.