Paul,
My “new” GPS died just as I was driving to see Darren. After driving blind
around all southern Brisbane trying to find a new GPS I was over 2 hours late getting
to see Darren at Billet Inc. Once there I was in heaven as he makes all Mazda Rotary
parts with the exception of the E shaft and gears, as to date there is no call for
these parts. If there is he can get another bloke around the corner to make these,
so parts for the rotary will be around until Darren dies which will hopefully be a
long time. All parts are from alloy. The wear plates are recessed into the plates
and made from cast iron, same as original. He also makes rotor housings and rotors
which are lighter than stock. Any configuration you want he makes, 13B, renesis, P
port or standard. I asked about making the engine with mounting eyes like a
lycoming, so they can be easily inter changed, Again “easy” was the answer. Whatever
you want, I can make!! I did try desperately to not look too excited in case the
price went up, but failed miserably. He makes rotors to whatever compression is
required.. Pictures are as follows. 1. Inside of front plate without the cast
insert. 2. Same plate with the cast insert sat in where it fits. (Actually it was
the wrong side plate but it shows the idea) 3. front plate (outside) ready for
whatever mount you specify, stock water pump and pulleys / ignition timing etc. 4.
New rotor 1 lb lighter than original. 5. Darren with a machined dry sump for a 20B
or whatever 3 rotor required. THe oil pump is apparently about $1400. Can be fitted
to any rotary. Aerobatics, here we come. 6. Rotor housing as he makes them with
additional cooling around the ignition area. Apparently stops warping under
sustained very high power application. There was much more, but best you get it from
Darren if interested. Neil In Oz.
http://www.billetinc.com.au/#
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.