Subject: 1st flight renesis P port
From: rotaryeng
Date: 7/12/2012, 11:39 AM
To: AAAA Put this in the To box

I do engine mount plans for free.

The distance varies but usually it is around 39 inches.

The 2.8 gear box allows the engine to rev to about 7500 RPM.
Prop RPM is 2630 so the prop tips are subsonic.
That allows a p-port engine to make about 250 HP

Also read this.

http://www.rotaryeng.net/mm-instruct.html


Paul Lamar


Jz Eldorado,
                     All I learned was really was here on this site
from
paul, for which I owe a great deal of gratitude.  THe engine mount was
designed by Paul and only slightly modified as necessary to fit.  From
memory Paul's measurement of 39 inches from firewall to prop flange is
correct, but will measure it if concerned.  I have a stock Renesis P
ported,
if you are going  Alloy you may have to shift something to keep
balance.  My
batteries are under the seats.  Just remember that if you are making
engine
mounts that the motor is offset 1.8 degrees to the right and 1.5 degrees
down. My primary muffler is a tangential muffler made by Plane exhaust
as
recommended by Paul again and then goes down to be split into two
pipes and
two mufflers under the fuse.  Both pipes finish about 2 feet behind the
pilot.   I am averse to flying behind a screaming "Chain saw".  Yes more
drag, but I no longer care.   Glasair are right to steer you away from
the
subaru 6 which is what I originally had.  Too heavy plus a few other
problems.  My C of G with the H6 suby was way out the front, putting the
stall speed nearly 10 kts above standard.   Without the cowling the C
of G
already looked right with the Rads back under the engine, not way out
the
front.  Did all the calcs for the C of G and it is near perfect. I am
a very
happy camper.  Have hundreds of photos, but best to get Paul to give
you my
email privately if you want to persue this way. Best is really to ask on
this site as many others have better ideas as well.  Neil.
-- I'm gonna wait until after Oshkosh to continue, but difinately, I'll go for the plans from you, Paul. Let me know what you need to start. Those pics from Neil are so clean. Nowhere have I seen such a nice, uncomplicated installation of the engine compartment. No clutter, and you can't see where the rubber band attaches. Nice. Oh, just to be clear, I take all advice, that's ALL advice. The guys who recommended not to do the sub 6, just never explained why. Neil did so in one simple sentence. I like that. I live in 11963 so if any body out there is in the neighborhood , give me a shout. Jack(jzeldorado) The length of the cowl from firewall to prop flange and a sketch of the firewall showing the position of the hard points. The angle of the firewall if the firewall if it is not vertical. Paul Lamar
-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.