Use the injector pules to fire both LS1 or RX8 coils as well as the injector!!.
These coils have built in switches so they do not need drivers.
Since the intake port is never fully closed on a p-port rotary, unlike a piston
engine, the injector can operate at 22 degrees BTDC on any rotor. The same time the
spark plugs are fired.
It just requires a small board to condition the injector open collector pules and
convert it it to 5 volts. An opto isolator will work.
No software mods required. With Ed's Carvers mechanical leaning idea (changing the
fuel pressure mechanically) you are good to go.
I should get a royalty fee for every MS 1 sold to the rotary crowd :)
Paul Lamar
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.