Subject: Last great idea to use one MS 1 per rotor. Correction.
From: rotaryeng
Date: 7/12/2012, 9:33 AM
To: AAAA Put this in the To box


 Use the injector pulse to fire both LS1 or RX8  coils as well as the
 injector!!.
 These coils have built in switches so they do not need drivers.

 Since the intake port is never fully closed on a p-port rotary, unlike a
 piston
 engine, the injector can operate at 22 degrees BTDC on any rotor.  The
 same time the
 spark plugs are fired.

 It just requires a small board to condition the injector open collector
 pules and
 convert it it to 5 volts. An opto isolator will work.

 No software mods required. With Ed's Carvers mechanical leaning idea
 (changing the
 fuel pressure mechanically) you are good to go.

 I should get a royalty fee for every MS 1 sold to the rotary crowd :)

 Paul Lamar

 Won't work with LS1 or RX8 coils. Must be a CD system. Also use the CAS to
 fire the CD system directly. I am still working on the LS1 and RX8 coil solution.

 Paul Lamar

 Paul,

FYI - Back when I first got my 20B I set it up on an engine stand with the
intention of doing some ground running.  Not having the Mazda ignition
module, or an EC-2,  I modified the CAS with three pickups, spaced 120*
apart around the inside of the stock CAS housing.  Then I connected the CAS
leads to three GM ignition modules, and fed the outputs to dual tower
coils, one for each rotor.  I could easily have fed the three signal GM
ignition module output leads into three MSD CD units, but I was building it
on the cheap, so I used Buick V-6 dual tower coils.  While it didn't have
spark advance, it did run quite well and was very simple.

The GM ignition modules are inexpensive and have been "road-tested" in
millions of GM vehicles.  The GM HEI ignition modules are also a favorite
of the Jeep crowd.  Might be worth looking into.

Mark S.

Thanks Mark.

I would like to avoid dependency on any OEM ignition system.
Also the HEI uses the old fashion coils.

I am with working with the guys at DIY Auto tune to have the MS calculate the dwell
so we can use RX8 coils. It just requires a bit of code addition.
They may decide to help.

It was the one MS per rotor that got their attention :)

BTW using one per rotor gives the computer more time to do extra stuff
like sending EFIS data to the notebook screen and logging  data on the hard disk.

Paul Lamar


-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.