Subject: New Megasquirt mother board rotary
From: rotaryeng
Date: 7/13/2012, 11:13 PM
To: AAAA Put this in the To box



   This will be the exact same size and have the same connectors so it
   will be interchangeable with a real Megasquirt card.

   The size is 4 by 6 inches.

   Paul Lamar



 Just to make sure we are clear here, this is the Megasquirt PCB3 board
 stuffed with mega-squirt 1 components?

 Ed Carver

 Not exactly. It will use the MC68HC908 and not the daughter card.
 The daughter card has the MC9S12C64 which is a faster processor. This apparently was
 necessary when they switched to C from assembly language.  Assembly always results in
 faster code but it take more time to write.  AKA bloat ware.

 To quote http://www.bgsoflex.com/megasquirt.html

 "All of the embedded microprocessor code executed for MegaSquirt-I™ was hand-written
 directly in assembler, not compiled from a high-level language. Working directly in
 assembler produces the tightest and fastest-executing code possible, even compared to
 the most efficient C compiler available. The result is that MegaSquirt™-I can provide
 real-time fuel calculations up to 16,000 RPM!"

 Here is a comparison jpg from B&G.

 I wrote an asm language system and designed a mother board in the late 1970's using a
 1 MHz 6502. The program was in 4K ROM and  did much more than any mega-squirt so far.
 A little bit later version of the 6502 doubled the speed to 2MHz.

 http://www.rotaryeng.net/RT1.pdf

 Also B&G were fond of using discrete transistor and a bunch of resisters when CMOS
 chips, 4049 and 4050, did the job better using less board real estate. CMOS chips can
 also be placed in high quality sockets for repair if necessary.

 The big change since 1970's has been chip integration and speed. Many of the chips I
 had on my SuperKim  board back in the 1970's have been integrated on the MC68HC908.
 Also the MC68HC908 instruction set is slightly better in some ways and worse in
 others compared to the 6502. The single chip computer community still hasn't caught
 on to the advantages of 8 latched hardware interrupts.

 Paul Lamar


It's been a long time since I've seen a 6502.  That's the CPU that I
learned assy code programming on.  In fact, the board I learned on used
eight toggle switches to set the program into memory one byte at a time
so the programming was actually in binary.  It was just manually
translated from hand written assy code.  When you hit the reset button
it would read in the instruction located at 00 hex and start execution
from there.

 Mark LaPierre

I guy by the name of Chuck Peddle worked on the 6800 and invented the PIA while
working for Motorola. Then he designed the low cost 6502 and went to management and
said "I have a better product." Motorola management said "we have a microcomputer we
don't need to improve it."

So Chuck quit and went to work for MOS technology and produced 6502 and the Kim 1.
I expanded the Kim 1 and called it the SuperKim. I went up to Atari in N Cal and got
an appointment with Chuck and asked him for permission to use the Kim name.
Apple adopted the 6502 and the rest was history.

As of 2009 Chuck was still alive.
www.retrobits.com

http://tinyurl.com/6lwmd5u


Paul Lamar

-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.