Subject: New Megasquirt mother board rotary
From: rotaryeng
Date: 7/14/2012, 6:20 PM
To: AAAA Put this in the To box


   This will be the exact same size and have the same connectors so it
   will be interchangeable with a real Megasquirt card.

   The size is 4 by 6 inches.

   Paul Lamar

 Looks good.
 Perhaps adding a Bluetooth chip (cost $1) would allow us to connect our
 laptop/tablet without wires.  My GPS receiver is Bluetooth and has
 performed flawlessly on every flight.

 Not sure what schematic/PCB program you are using, I have found
 DesignSpark to be excellent, it is free yet not locked into one PCB
 manufacturer thus output can be manipulated in many ways.  If you design
 via schematic it features an auto PCB layout if you wish.

 Terry Adams
 KSCK

 Great idea. I'll take a look at it depending on the real estate.
 I am using a crude free one called ExpressPCB.
 Thanks for the tips Terry.

 Paul Lamar

As you work on designing the new board, if you choose or need to use any
SMT components and would like to fabricate a prototype perhaps I can
offer my assistance in reflow soldering the board for you. I can handle
MSOPs, but I do not like DFN/QFN components unless they have edge
exposed pads.

Terry Adams
KSCK

Thanks Terry. I'll keep that in mind. I think I have enough real estated to do the
old fashion dips. When you get right down to it it is pretty simple without all the
injector damping stuff. Here is the schematic.

Paul Lamar
-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.