Paul Lamar,
I have been interested in using a rotary engine in a aircraft for a long time.
Am interested in news letter.
>From what I have previewed on the site I visited a lot of people have accomplished
this. I have a few questions.
1. To what percent/ratio will the rotary engine run on gasoline/ethanol mixture?
2. Can it be modified to run on 100% ethanol?
3. Can 4 or 6, rotary "cylinder" blocks be combined with custom drive shaft,
timing modifications and etc. to make a much large hp. motor?
Thanks
Randall Davis
1. Zero to 100%
2. Yes
3. Up to five have been done by CW. Emon Hurly built a six but I would be worried
about the E-shaft breaking. Emon was the only guy to step off a 156 MPH NSU
supercharged Wankel 400HP powered motorcycle and lived to tell about it :)
http://www.hurleyrotary.com/
If you use two 4 rotors back to back and take the power out of the center that would
work. You would be looking at over 1800 HP NA and near 3000 HP turboed with off the
shelf modified Mazda parts running on gasoline.
Paul Lamar
Mercedes' C 111 didn't have a five rotors Wankel ? GB.
Guido Bartolomei
3 & 4
"The performances of the C111 even with the three rotor engine was convincing right
from the start. In 1969, the Wankel engine developed 280 hp from 600 cubic
centimeters of chamber volume per rotary piston [3.6 L] and gave the car a top speed
of 260 kph; with this engine the car accelerated from standstill to 100 kph in five
seconds. The C111 II of 1970 was powered by a large four rotor Wankel engine [4.8 L]
which developed 350 hp and gave the car a top speed of 300 kph [187 MPH]. The second
C111 accelerated from standstill to 100 kph in 4.8 seconds."
Paul Lamar
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.