Subject: newsletter interest & questions
From: rotaryeng
Date: 7/15/2012, 8:06 PM
To: AAAA Put this in the To box


 Paul Lamar,
 I have been interested in using a rotary engine in a aircraft for a
 long time. Am interested in news letter.
 From what I have previewed on the site I visited a lot of people have
accomplished
 this. I have a few questions.

     1. To what percent/ratio will the rotary engine run on
 gasoline/ethanol mixture?
     2. Can it be modified to run on 100% ethanol?
     3. Can 4 or 6, rotary "cylinder" blocks be combined with custom
 drive shaft,        timing modifications and etc. to make a much
 large hp. motor? Thanks Randall Davis

 1. Zero to 100%
 2. Yes

 3. Up to five have been done by CW. Emon Hurly built a six but I
 would be worried about the E-shaft breaking. Emon was the only guy
 to step off a 156 MPH NSU supercharged  Wankel 400HP powered
 motorcycle and lived to tell about it :)

 http://www.hurleyrotary.com/

 If you use two 4 rotors back to back and take the power out of the
 center that would work. You would be looking at over 1800 HP NA and
 near 3000 HP turboed with off the shelf modified Mazda parts running
 on gasoline.

 Paul Lamar

 Mercedes' C 111 didn't have a  five rotors Wankel ? GB.
 Guido Bartolomei

 3 & 4

 "The performances of the C111  even with the three rotor engine was
 convincing right from the start. In 1969, the Wankel engine
 developed 280 hp from 600 cubic centimeters  of chamber volume per
 rotary piston [3.6 L] and gave the car a top speed of 260 kph; with
 this engine the car accelerated from standstill to 100 kph in five
 seconds. The C111 II of 1970 was powered by a large four rotor
 Wankel engine [4.8 L] which developed 350 hp and gave the car a top
 speed of 300 kph [187 MPH]. The second C111  accelerated from
 standstill to 100 kph in 4.8 seconds."

 Paul Lamar

 I believe Guido was enquiring about the CW 5 rotor engines. These are larger
displacement per rotor industrial engines used by the US armed forces more
than any one else, and were heavy fuel engines. Construction would be cast
iron as industrial applications are not too concerned about weight.

Dale Davies

They made some aluminum ones I think. Military use. I saw one in a secret warehouse :)


Paul Lamar


-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.