Subject: heater outlet and oil hose size
From: rotaryeng
Date: 7/19/2012, 5:56 PM
To: AAAA Put this in the To box


 Where do I connect the small 1" hose outlet used for the heater in
 the car?  What type of hose should I use for the oil lines?  Thanks
 for any help Joe Berki

  The nipple for the heater is on the top of the rear(car) end housing.

  AN8 or AN10.

  Paul Lamar

 Paul,
 Does this heater hose connection get blocked off or does it get
 plumbed into the system?

 Joe Berki

 Block it off if you don't have a heater on a pusher. On a tail
 dragger vent it back to the water pump. Here is a jpg from my book.
 How to Cool your Wankel.

 Paul Lamar

 1"?? Most auto heaters have 5/8" hose from the thermostat housing (engine
side) to the heater and 3/4" return to the water pump suction. Some use both
as 5/8". That looks like a de aeration vent to the surge tank.

Dale Davies

Helps to fill the block as the engine is tilted up in a tail dragger.
You get a big air bubble in there.

Paul Lamar

-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.