Subject: heater outlet and oil hose size
From: rotaryeng
Date: 7/19/2012, 7:02 PM
To: AAAA Put this in the To box


  Where do I connect the small 1" hose outlet used for the heater in
  the car?  What type of hose should I use for the oil lines?  Thanks
  for any help Joe Berki

   The nipple for the heater is on the top of the rear(car) end housing.

   AN8 or AN10.

   Paul Lamar

  Paul,
  Does this heater hose connection get blocked off or does it get
  plumbed into the system?

  Joe Berki

  Block it off if you don't have a heater on a pusher. On a tail
  dragger vent it back to the water pump. Here is a jpg from my book.
  How to Cool your Wankel.

  Paul Lamar

  1"?? Most auto heaters have 5/8" hose from the thermostat housing (engine
 side) to the heater and 3/4" return to the water pump suction. Some use
 both
 as 5/8". That looks like a de aeration vent to the surge tank.

 Dale Davies

 Helps to fill the block as the engine is tilted up in a tail dragger.
 You get a big air bubble in there.

 Paul Lamar

Paul,

We ought to differentiate between the small 1/4" port on the top of the
rear side housing and the larger 5/8" (?) port just below the oil filter
pad.  We typically use the 1/4" port for an air bleed back to the swirl
tank, and the 5/8" port for a cabin heater, if used, otherwise just block
it off.  I wouldn't want to route it back to the water pump as this is
heated water.  If anything, I would route it to the inlet side of the
radiator.

BTW, it isn't easy blocking the 5/8" port off as it is an oddball size, and
there isn't enough material to drill it out to the next larger size.  I
ended up cleaning it thoroughly and then filling the nipple with Devcon.

Mark S.

You are absolutely right.
However the output part of the water pump is the inlet side of the rad :)

Paul Lamar

-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.