Subject: heater outlet and oil hose size
From: rotaryeng
Date: 7/20/2012, 4:25 AM
To: AAAA Put this in the To box


 Where do I connect the small 1" hose outlet used for the heater in
   the car?  What type of hose should I use for the oil lines?  Thanks
   for any help Joe Berki

    The nipple for the heater is on the top of the rear(car) end housing.

    AN8 or AN10.

    Paul Lamar

   Paul,
   Does this heater hose connection get blocked off or does it get
   plumbed into the system?

   Joe Berki

   Block it off if you don't have a heater on a pusher. On a tail
   dragger vent it back to the water pump. Here is a jpg from my book.
   How to Cool your Wankel.

   Paul Lamar

   1"?? Most auto heaters have 5/8" hose from the thermostat housing (engine
  side) to the heater and 3/4" return to the water pump suction. Some
 use both as 5/8". That looks like a de aeration vent to the surge tank.

  Dale Davies

  Helps to fill the block as the engine is tilted up in a tail
 dragger. You get a big air bubble in there.

  Paul Lamar

 Paul,

 We ought to differentiate between the small 1/4" port on the top of the
 rear side housing and the larger 5/8" (?) port just below the oil filter
 pad.  We typically use the 1/4" port for an air bleed back to the swirl
 tank, and the 5/8" port for a cabin heater, if used, otherwise just block
 it off.  I wouldn't want to route it back to the water pump as this
 is heated water.  If anything, I would route it to the inlet side of
 the radiator.

 BTW, it isn't easy blocking the 5/8" port off as it is an oddball
 size, and there isn't enough material to drill it out to the next
 larger size.  I ended up cleaning it thoroughly and then filling the
 nipple with Devcon.

 Mark S.

 You are absolutely right.
 However the output part of the water pump is the inlet side of the
 rad :)

 Paul Lamar


 Correct me if I am wrong but does the water pump suction come from the cool
part of the radiator and the pump out pressurize the block?

Dale Davies

Yes.
It is more like the pressure is constant in the entire system.
There may be a small pressure drop across the pump but we use a 30 psi pressure cap
to raise the boiling point.

What is rather confusing about the 13B Mazda water pump is both inlet and outlet of
the block water jacket goes through the pump body.

The pump is built into the front cover on the RX8.

Paul Lamar
-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.