I have thought about it and thought about it and I have come to the conclusion the
best way to do it is in hardware. The MC68HC908 does not have the additional timer
needed to do it in software.
This uses a CMOS 555 pulse width generator to generate a pules width that will delay
a 3 ms one shot to fire LS1 coils and RX8 coils. These coils will overheat and fail
if the dwell is much longer than 4 or 5 ms. I have tested all these circuits and the
CMOS 555 pulse width generator works extremely well. Much better than my wildest
expectations. It works the same way the 555 EFI system works.
The RPM parameter is in the form of an analog voltage. In other word an analog tach.
It is a simple circuit that generates a DC voltages when fed with a constant pulse
width depending on the RPM. Basically a resister and capacitor. High RPM more
voltage low RPM less voltage.
This is fed into the CMOS 555 to generate a varying pulse width delay. Low RPM long
delay. High RPM short delay. Therefor the signal is reversed by an inverting op amp.
The whole rig is triggered about 50 degrees BTDC.
Here is the preliminary circuit.
I'll do a bunch of tiny PC boards and sell them. You can buy the parts from digikey.
Paul Lamar
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.