Hi
Thanks for quick reply. I am looking at using a single injector only
as a performance booster on an old diesel motor injecting small
quantities of petrol. Was going to use TPS to vary injector output,
 4 x pulse outputs off the crank.Thought that the 555 was a good
place to start playing.
 Scott Pearson
 That should work.
Most diesel run WOT all the time and the amount power and fuel flow
is controlled by the TPS. You'll get smoke like at a tractor pull :)
Make sure you use the CMOS version of the 555.
 Paul Lamar
 Scott,
re you planning to use gasoline or diesel fuel? Gasoline has a major problem
with the high compression and WILL cause knock. I would use propane or CNG
nstead if that is the case.
Dale Davies


Dale
Have been using 20 % petrol(high octane Approx 105) using wvo(waste veg oil) just
seems to advance ignition on the diesel motor. Thought that electronic injection (as
sorts) would be a bit me precise in volume and injected timing This a booster ,not on
100% of the time. Mate,just playing around to keep the busy and learning at the same
time. love to play with all sorts of different stuff.Any input is taken on-board and
not to have the nose turned up at it, if you know what I mean.
Thanks In Advance
scott


-- 
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.