Hey Gang, Milo. I need a standard transmission flywheel Need not be
servicable
in a regular sense to be modified for an alternator/ignition mockup. Are
all
manual transmissions flywheels the same? A junker from any model would be
Ok
if it would fit an RX8 block. Have fitted a 15 amp alternator between the
flywheel and engine block, and mechanically it fits, now need to test the
mechanical aspects on a test rig driven by an electric motor. We will
shave
the flywheel to fit. As soon as we have run it a bit will publish the
details. Milo
This is an excellent idea with or with out the alternator/ignition.
The manual transmission flywheel is much stronger in the hub area than the auto tx
flex plate where you need it. We have had trouble with flex plate cracking near the
hub on high power engines.
All you need to is find a lathe that can handle 13 inches diameter and machine off
the unneeded weight.
Paul Lamar
--
Will you pay for shipping Milo? It's heavy around 35 pounds.
Or you can wait until the beginning of Oct when I will be driving through
Tx.
Send me your shipping address by private email.
Paul Lamar
Paul, thanks I would appreciate that. I have your
address will send you the cash, just let me know how much.
Also appreciate you design suggestions. I am at a lost electrically. I have
some time to take care of the mechanicals. Plan to test to 7500 rpm the
mechanical first. After that I will layout all the pieces and seek
assistance for the electrical. Just today finished installing the stator. It
is a Briggs & Stratton setup, going to try the alternator part first then
the alternator/ignition combination. The alternator is supposedly good for
15 amps, but all of this hinges on the mechanical aspects, high RPM loads,
good insulation, etc.
Gotcha covered my lathe is good for 16 inches. Milo
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.


