I hope this is enough info for you to CAD my mount.  I don't have a
cowling as of yet.  Seemed like that would be puttin the cart before
the ....  Question.  there is a Maszda Renesis engine on Barnstormers
that has a psru/(tracy crook), but it is an RV 8 mount.  There are
extras, but no oil, or water cooling equipment.  Asking 6900.  Was
just recently rebuilt.  forgot who,  but here is the link.
barnstormers=search=mazda---- it pops up first.  only one there.  just
thought i'd ask your opinion.  Seems like a reasonable deal.

Jack Eldo

It is nice to fit the engine in the stock cowl as custom cowls are a lot of work.
You might try to sell the mount and cowl to an RV8 guy. The mount  is less than ideal
anyway. Very expensive and prone to oil leaks. The front rubber bushing tend to over
heat. One or two critical brace tubes are missing. Other than that it will work in an
RV8.

The engine looks good on the outside. Depends on the condition. Modest HP. My guess
from looking at the intake manifold as well as I can see it around 190 HP if you are
lucky. No way 220 HP. That assumes a 2.95:1 gear box and and a prop set for max take
off RPM of 7500. It's no P-port :)

Motor mount later.

Paul Lamar
-

Here is Neil Ungers Glastar mm.

I can give the dimensions later.

Paul Lamar

-- 
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.