Subject: Zeth Glastar--attn Herb Karkheck=pic of Neil Unger's glastar
From: rotaryeng
Date: 8/14/2012, 9:36 AM
To: AAAA Put this in the To box


Neils First Smoke 14 Apr 12

Jack

Did you have a question about this Jack.

Herb was on here when Neil talked about his first smoke.

Paul Lamar

no.  I thought Herb wanted to see the Glastar, but I guess it is pics
of the engine on barnstormer.  while i'm here, Neil made his own
cowling.  was it to fit the rx8 mounted on  your custom mount design?
something like that would be perfect for me, does Neil have a mold?
The fellow with the test setup is asking 8K or BO  for the engine, redux
and cooling equipment.  that one has the P intake set-up.  In Texas.
seems as tho an abundance of kit builders are out thata way.


Jack

Jack,
        Yep I was silly enough to do the lot and have made a cowling mold to
fit the glastar with the thrust line where the original was.  Just depends
if it is what you want.  At the moment it appears that the heat exchanger
opening may be too large, time will tell, but it is much easier to close it
up then try and make it bigger.  Neil.  My engine mount was based on Paul's
design.  I still have most of the jig that I used to make it also.  Can send
measurements.  Neil.


I made this perforated angle steel jig once. It was a lot of work to
make the just
the jig.

The easiest thing is get a steel  tube about  three to six inches in
diameter and with a length from the firewall to the motor plate.  Weld a 10"
by 10" square steel flange on both ends.  Bolt it the firewall or thick
particle board in the right place and one of Jeff's motor plates on the
forward end.  That's it.  Jig is done

If you want down or side thrust use a protractor and shim it with
washers.

I have a guy in Ventura CA that will tig weld a MM for you. I am here
and can watch over it for free. http://doritefab.com/ I have one of
Jeff's plates  that he can use to make the jig.

Paul Lamar


Neil, I'm not able to take advantage of the rx8 on Barnstormers.
Please get it.  I'm gonna be a bit getting my loan, and I do believe I
need to have the mount built for me.  My Tiging is up to the beautiful/
structural weldments you've done.  the pics are very helpful.  I need
to get my reverse loan, then I can move forward.  Hi Herb.  Nice to
have a Glastar/ rotary friend. Jack


-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.