Subject: retard timing for the turbo
From: rotaryeng
Date: 8/22/2012, 3:22 PM
To: AAAA Put this in the To box


  Hey, Kevin, sorry to be slow but you asked for thoughts about retard
  timing for the turbo, and I want to do some more investigating (I care,
  because I'm planning a turbo, too), but I do have a couple thoughts for
  consideration.
     The engine has no clue how the manifold came to have the air
  pressure it has, and doesn't care (with caveats).  So, I agree that
  maximum boost should probably be set at 8 psi, but I think the timing
  retard may bear thinking about.  What mainly risks detonation on an
  engine (assuming no stupid levels of boost) are hot intake charge,
  excessive leaning under load, and excessive cylinder pressure when under
  high load/low RPM conditions.  They are interrelated.
    My gut reaction is aircraft are lucky in not having a lot of the
  problems autos face, and for which autos use huge amounts of retard.  We
  don't have to accelerate from low engine RPM at high load, and we often
  soon escape the hot ground level air temps.  A rotary in particular will
  almost always be at what an auto would consider very high RPM (generally
  calling for larger advance, not less) when it is under load.  And an
  aircraft can be manually set on the rich side when at greatest risk
  (take off), which helps cool the charge and has a slower burn rate,
  again helping to avoid the need for extreme retarding.  I'm assuming no
  one would install a turbo without an intercooler, and of course at
  altitude aircraft have a cooler environment for both initial intake
  charge and intercooler cooling.
     I guess bottom line it seems like a bit of retard is likely wise,
  particularly at high load/low altitude like take off, but probably more
  critical is keeping the boost limited during those conditions so the
  manifold pressure never gets too far above what a great breathing n.a.
  motor might see at sea level (and you hear no one calling for retard
  there).  Remember retarding carries its own problems, primarily that if
  the charge doesn't have time to fully burn, you're going to get a lot of
  extra heat in the engine and especially in the turbo/exhaust as it
  continues burning on the way out.  Seems to me that a retard factor
  should be applied, but perhaps only when the manifold pressure and/or
  temperature is elevated above what a n.a. motor might see.  Well, and
  maybe even at cruise if you have altitude compensated the manifold
  pressure (so it thinks it's back at ground level) but are wanting to
  lean it (some retard should be okay there, because a lean mixture will
  burn much more quickly anyway, but since the RPM is high and the load a
  bit lighter, I still wouldn't think too much).  Even where some retard
  is called for, because of the generally high RPM of the rotary, and
  quick-acting, non-valve actuated exhaust system, maybe not retard on as
  steep of a curve or much total as on a auto.  Just thinking out loud.
  Greg




 Paul--don't know if it is instructive but here are the general guidelines
 we
 [Early Power Sport] used for spark lead on our peripheral port rotary
 aircraft
 engines--sustained high rpm/high power settings for both types of fuel
 injection (direct injection earlier development and later port injection).

 For competition purposes used coldest possible sparkplugs.
 As you see below were very conservative on spark lead which was same both
 lead and trail.

 Normally-aspirated peripheral port--regardless of port timing --were
 addressed as if they were basically boosted engines due to extreme duty
 cycle as compared to ground vehicle use. These numbers depended on altitude
 at which the power-settings were to be used; i.e. sea level vs 8,000+ feet.

 Regular/moderate cross country/ferrying--18 degrees both lead and trail
 Baseline for sustained high power setting 10 to 15 degrees
 Nitrous  for time-to-climb competition to 3,000 ft. was 15 degrees (350 hp)
 100 mile race WOT/max power--10 to 12 conservative; 15 degrees aggressive

 Steve Beckham

 BTW Steve's RV3(?) airplane set the unofficial time to climb record from a
 dead stop
 to 3000 feet in less than a minute. This beat Pushy Galore and dozens of
 other
 contenders at Sun & Fun over a several year period.

 Paul Lamar

This for Steve Beckham,
     Steve what did you use for fuel in your "Power Sport" engines
?..........If 100LL was used how
would the use of unleaded auto fuel (minus alcohol) either regular or hi
test have affected the
spark lead of your engines??..........

-- Kelly Troyer Dyke Delta_"Eventually" 13B_RD1C_EC2_EM2
-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.