Hey, Kevin, sorry to be slow but you asked for thoughts about retard
timing for the turbo, and I want to do some more investigating (I care,
because I'm planning a turbo, too), but I do have a couple thoughts for
consideration.
The engine has no clue how the manifold came to have the air
pressure it has, and doesn't care (with caveats). So, I agree that
maximum boost should probably be set at 8 psi, but I think the timing
retard may bear thinking about. What mainly risks detonation on an
engine (assuming no stupid levels of boost) are hot intake charge,
excessive leaning under load, and excessive cylinder pressure when under
high load/low RPM conditions. They are interrelated.
My gut reaction is aircraft are lucky in not having a lot of the
problems autos face, and for which autos use huge amounts of retard. We
don't have to accelerate from low engine RPM at high load, and we often
soon escape the hot ground level air temps. A rotary in particular will
almost always be at what an auto would consider very high RPM (generally
calling for larger advance, not less) when it is under load. And an
aircraft can be manually set on the rich side when at greatest risk
(take off), which helps cool the charge and has a slower burn rate,
again helping to avoid the need for extreme retarding. I'm assuming no
one would install a turbo without an intercooler, and of course at
altitude aircraft have a cooler environment for both initial intake
charge and intercooler cooling.
I guess bottom line it seems like a bit of retard is likely wise,
particularly at high load/low altitude like take off, but probably more
critical is keeping the boost limited during those conditions so the
manifold pressure never gets too far above what a great breathing n.a.
motor might see at sea level (and you hear no one calling for retard
there). Remember retarding carries its own problems, primarily that if
the charge doesn't have time to fully burn, you're going to get a lot of
extra heat in the engine and especially in the turbo/exhaust as it
continues burning on the way out. Seems to me that a retard factor
should be applied, but perhaps only when the manifold pressure and/or
temperature is elevated above what a n.a. motor might see. Well, and
maybe even at cruise if you have altitude compensated the manifold
pressure (so it thinks it's back at ground level) but are wanting to
lean it (some retard should be okay there, because a lean mixture will
burn much more quickly anyway, but since the RPM is high and the load a
bit lighter, I still wouldn't think too much). Even where some retard
is called for, because of the generally high RPM of the rotary, and
quick-acting, non-valve actuated exhaust system, maybe not retard on as
steep of a curve or much total as on a auto. Just thinking out loud.
Greg
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.