Subject: retard,timing for the turbo
From: rotaryeng
Date: 8/26/2012, 10:32 PM
To: AAAA Put this in the To box



Hey,  Kevin, sorry to be slow but you asked for thoughts about retard
timing for the turbo, and I want to do some more investigating (I
care,  because I'm planning a turbo, too), but I do have a couple
thoughts for  consideration.     The engine has no clue how the
manifold  came to have the air pressure it has, and doesn't care
(with  caveats).  So, I agree that maximum boost should probably be
set at 8  psi, but I think the timing retard may bear thinking about.
What  mainly risks detonation on an engine (assuming no stupid
levels of boost)  are hot intake charge, excessive leaning under load,
and excessive  cylinder pressure when under high load/low RPM
conditions.  They are  interrelated.    My gut reaction is aircraft
are lucky in not  having a lot of the problems autos face, and for
which autos use huge  amounts of retard.  We don't have to accelerate
from low engine RPM at  high load, and we often soon escape the hot
ground level air temps.  A  rotary in particular will almost always
be at what an auto would consider  very high RPM (generally calling
for larger advance, not less) when it is  under load.  And an
aircraft can be manually set on the rich side when  at greatest risk
(take off), which helps cool the charge and has a  slower burn rate,
again helping to avoid the need for extreme  retarding.  I'm assuming
no one would install a turbo without an  intercooler, and of course
at altitude aircraft have a cooler environment  for both initial
intake charge and intercooler cooling.      I guess bottom line it
seems like a bit of retard is likely wise,  particularly at high
load/low altitude like take off, but probably more  critical is
keeping the boost limited during those conditions so the  manifold
pressure never gets too far above what a great breathing n.a.  motor
might see at sea level (and you hear no one calling for retard  there)
.  Remember retarding carries its own problems, primarily that  if
the charge doesn't have time to fully burn, you're going to get a
lot  of extra heat in the engine and especially in the turbo/exhaust
as it  continues burning on the way out.  Seems to me that a retard  factor
should be applied, but perhaps only when the manifold  pressure
and/or temperature is elevated above what a n.a. motor might  see.
Well, and maybe even at cruise if you have altitude compensated the
manifold
pressure (so it thinks it's back at ground level) but are  wanting to
lean it (some retard should be okay there, because a lean  mixture will
burn much more quickly anyway, but since the RPM is  high and the
load a bit lighter, I still wouldn't think too much).   Even where
some retard is called for, because of the generally high RPM of  the
rotary, and quick-acting, non-valve actuated exhaust system,  maybe
not retard on as steep of a curve or much total as on a auto.   Just
thinking out loud. Greg

Greg;

Thanks. I agree with you  on most points- I have read where boosted engines
are retarded at high  boost to counter detonation, with
recommendations for boost at 8 psi to  have timing at 4 deg BTC.
Megasquirt code for the turbo rotary has a table  with just such a setting.
I agree that aircraft engines operate in a  different environment
than cars, but I would consider it a more severe  environment.
Yesterday in South Florida at X51 the reported temp was 92,  with our
C172 seeing over 100 at the end of runway 10 before takeoff. We  used
full power for takeoff and held this setting until 2000 feet.  Our
density altitude was 1700 feet making climbing a bit slow. We  were
doing practice ILS approaches at KTMB with touch and goes, go  around
and do it again kind of scenario. The tower required max rate  of
climb until 2000 feet for each takeoff. At max power and full  rich
our CHTs were approaching 400 deg, and our CHTs were high as  well.
The point is that for the first critical minutes of flight, we  are
WOT, rich, hot, and running as hard as we can. It is only later  than
the air cools and we get to pull back to cruise. As far as  the
intercooler, I have seen many GA planes that dont have them  because
they are used for normalizing not extra power, and don't kick  in
until higher and cooler air. For my application I will incorporate
an  intercooler, but I dont expect it to be of much use at the end of
a 100  degree runway. The efficiency of any cooler is dependent on
the  differential temp of the air outside and the air inside, as well
as the  density of the cooling medium. Neither is optimum here at  the
moment.

Contrast this to a car- a race car sees brutal  conditions for 8 seconds
max. An automobile sees max power and boost for a  few seconds to
take off from a stop light or while passing, again for a few  seconds.

Like you I will keep doing more research, but I have concerns  about it.
Depending on what I discover, I will likely tie my boost (i.e.  wastegate
control) to an adjustment related to a knock sensor or intake  temps,
with a manual adjustment. If I use an electronic automatic  wastegate,
the control will be electronically adjusted, manually it  could be
adjusting a tension via a vernier and cable like most planes have  as
a mixture control.  At worst I could reduce the boost by a couple  of
psi and protect the engine at the cost of a couple hundred feet of  runway.

Kevin Alderman

A Detroit Diesel Series 60 powered truck  on a chassis dyno will have a
turbo
out to the intercooler temp up to  350*F. At 100* OAT, that is 250*
differential. Cooling helps.

Dale  Davies


The function of ignition timing is to allow the highest cylinder pressure
to develop at 50 degrees after top dead center. This may require a timing
event at 15 degrees or at 2 degrees, depending on the amount of boost
pressure. Racing Beat says no split timing on boosted engines. They use 10
degrees maximum timing under boost. Closed throttle high vacuum may require up  to
44 degrees of advance to get the idle fuel mixture to light and burn to
some  extent before the exhaust port opens.

Lynn E. Hanover



-- The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube key word PaulLamar2 Copyright 1998-2012 All world wide rights reserved.