Subject: Hushpower autopsy-Mazda rotary mufflers
From: Paul lamar
Date: 9/8/2012, 5:43 AM
To: AAAA Put this in the To box


We'll I finally got some time off to check out my airplane after the round trip from Everett to Medford. The heat cooked my left brake line, and I suspected the muffler had too much back pressure, so I resolved to investigate. Here's what I found when I removed my Hushpower from the airplane. There is way too much heat coming off my
muffler- the powder coating on my engine mount is cooked near the exhaust pipes, even though I coverd them with fiberfrax and placed a SS heat sheild to cover the tubes from view of the exhaust. The muffler was making like a baby rattle so I cut it open and this stuff came out of the inlet side. I'll send more pictures of the innards.

What I have is an RV-4 with the radiators and oil cooler hung underneath the plane in a scoop that is reminiscent of a P-51. I had the muffler submerged under the fuselage. I"m thinking that it would be better to have the exhaust pipes exit the side of the cowl, in a reverse scoop that would vent a huge amount of heat from the cowl. The muffler would be a straight 6 foot muffler like the one Paul outlined about a week ago. It would be mounted along the side of the fuselage. I hate to ruin the clean lines of an RV-4, but nothing would ruin it more than having a mechanical failure due to excessive exhaust heat bringing the plane down. My biggest worry about this rotary conversion is excessive exhaust heat and how to manage it effectively.

Here is the muffler cut open. The red chunks are what is left of the melted insulation material between the perforated inner case and outer. The outer case showed signs of bulging. The perforated inner case was split on the seam closest to the camera. The inner cone material which is also perforated was mostly gone, but big chunks were still left inside the muffler and undoubtedly were causing some obstruction.

Here's the split in the inner perforated case. Not real confidence inspiring.


Crap that I shook out of my baby rattle/Hushpower muffler.


Brian Trubee

That will work out OK but I would put it on the bottom like Mike did.
I think you could get the rad under the engine.

Either that or use a narrower rad and put it next to the rad under the fuse.

Paul Lamar


If you ever replaced mufflers on a 2nd or 3 gen RX7 you would know that Mazda built heavy, massive mufflers. I have a couple around here. Wonder what the inside design is like? Maybe I should cut one open.
Marc Wiese

That would  be interesting. Measure the sheet metal thickness.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.