Barry,
Before we go too much further, we need a PSRU that can handle 500+hp.
We've already had flywheels [flex plate] disintegrate and my
input shaft broke the
lock pin. I would consider installing a turbo, but in my opinion, the
psru is the weakest link.
Mark
P-port 20b
My last trip to Tracy's we discussed this. His recommendation is to use
an aftermarket aluminum flywheel and attach the PSRU input to that. His
latest iteration of the PSRU will attach to this flywheel easily he says.
As far as the lock pin, that would take more thought. Drilling it out
and installing a larger diameter pin will increase the shear of the pin
itself but at a cost to the strength of the shaft itself.
Kevin Alderman
Just install two lock pins 90 degrees to each other.
We did that on Dave's turbo Reno racer.
When I get home I will send a dwg. We have been around and around on
this. I am surprised Tracy did not mention it or start doing it.
Paul Lamar
Other than the weight, I take it there was no problem with the flywheel
Dave installed?
Re: the pins: is it possible that the pins were transfering the power and
the pin bores were tight and the spline clearance was allowing the power to
try to flex the pins?
Dale Davies
Dave has reported no problem so far with the steel flywheel.
BTW If you can't handle putting two pins in the sun gear send it to me and
I
will do
it. I have done a couple already,
Paul Lamar
Is Dave Leondard racing at Reno again this year?
Chris Cosman
I don't think so.
Paul Lamar
To All,
While we are addressing PRSU issue's, here is another one. I'm
mounting my prop extension and prop; In doing so I have found
that my prop tips move about 1". Is this too much back-lash? Seems
like I remember hearing that it should be around 1/4". Any suggestions
would be appreciated . Thanks!
Frank Clementi
Mine moves about an inch as well. Next time I go to the hangar I will
measure it.
Paul Lamar
Paul,
Tracy recently told me the backlash should be between 3/8 and 5/8".
Mark
I'll go out today and see what mine is.
Frank, What gear box do you have? 2.17 or 2.85?
Paul Lamar
Paul,
I have the 2.174 PSRU.
Frank
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.