Xcessive Manufacturing 20B Lower Intake Manifold (LIM)
http://www.xcessivemanufacturing.com/ONLINESTORE.html?cid=9&step=2
Just thought I'd share what Xcessive has been working on as of late.
Full length version:
Xcessive's all new cast lower intake manifold for the 20B is based on the
same concept as our original 13B-REW manifold, better runner flow balance,
more volume and more fuel. We've made these manifolds with 6 injector bosses
machined to fit Bosch type top feed injectors with 14mm o-rings without any
adapters. We've placed all the injectors on the inside of the manifold to
keep them away from heat leaving more room on the outside for turbo motors
as well as a cleaner install.
The new lower manifold fits stock upper castings and comes in both a full
height (stock) and short versions. This is the FULL HEIGHT (stock) version.
They are also available with and without fuel rails. This manifold kit
includes the fuel rail assembly. The fuel rail has 3/8" NPT ports on both
ends with a -8 (1/2", 13mm) through hole and comes with the apropriate stand
off's for full height top feed injectors. No more welding bosses onto a
stock manifold and chopping and welding the upper flange, we've done it all
for you in a single brand new piece that'll also out flow a stock manifold.
This Kit Includes
New cast manifold - Full height (stock) version
6 port fuel rail for top feed injectors
Rail stand off brackets and bolting hardware
Front mounting bolt (New boss height)
There is also a short version for easier swapping into non JC cosmo chassis'
Short version:
Quote from Xcessive's website:
Xcessive's all new cast lower intake manifold for the 20B is based on the
same concept as our original 13B-REW manifold, better runner flow balance,
more volume and more fuel. We've made these manifolds with 6 injector bosses
machined to fit Bosch type top feed injectors with 14mm o-rings without any
adapters. We've placed all the injectors on the inside of the manifold to
keep them away from heat leaving more room on the outside for turbo motors
as well as a cleaner install.
The new lower manifold fits stock upper castings and comes in both a full
height (stock) and short versions. This is the short version that is 1 1/2"
(38mm) shorter than stock. They are also available with and without fuel
rails. This manifold kit includes the fuel rail assembly. The fuel rail has
3/8" NPT ports on both ends with a -8 (1/2", 13mm) through hole and comes
with the apropriate stand off's for full height top feed injectors. No more
welding bosses onto a stock manifold and chopping and welding the upper
flange, we've done it all for you in a single brand new piece that'll also
out flow a stock manifold.
This Kit Includes
New cast manifold - Shortened version
6 port fuel rail for top feed injectors
Rail stand off brackets and bolting hardware
Front mounting bolt (New boss height)
If they can make stuff like this for the 20B RX7 conversion crowd, why can't
they make an intake set up for us for BOTH the 13B and 20B?
Marc
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.