Subject: P-port low rpm performance?
From: rotaryeng
Date: 10/13/2012, 5:02 AM
To: AAAA Put this in the To box

   I was reading on an aircraft forum last night that the p-port rotary
   doesn't make much power below 5000rpm, how accurate is this? if so does
   this mean economy cruise is difficult to achieve? My airplane spec calls
   for 160-210hp, so that is about 135hp for cruise. With a p port at 250hp
   I would have great speed from the extra hp at altitude at WOT and i can
   just limit manifold pressure in the lower levels to 210hp to prevent the
   engine departing and taking the firewall with it. Maybe the compromise
   is with the length of the intake runners? Is it really possible to have
   the best of both worlds here or do I need a reality check?

   Alex

   I depends on the intake runner length. Make it 24 inches and that
   will move the best BSFC point down the RPM range. You will lose a
   bit of power at 7500 RPM but your cruise prop may prevent that max
   RPM anyway.
   I assume a fixed pitch prop. If you want the best of all worlds use
   a variable pitch prop and a trombone intake manifold like the Le
   Mans engine had.

   Paul Lamar

On my planning I was leaning towards a fixed pitch prince p-tip, try
keep it lighter, cheaper,simpler

Prince claim an effective "increase" in prop diameter with their design
because of not losing the lift at the tips, they also claim some of the
benefits of variable pitch, (all on their website) My max prop diameter
is 74 inches, more diameter and i cut grass, so if the hype makes the
diameter effectively 76"+ then by my limited understanding with the 2:85 i can go 72" for more rough field clearance or 74" and enjoy the
benefits of an effective 76" prop

Alex

The diameter and pitch of the prop determines the max HP. If the engine can achieve 7500 RPM on take off then you will get 250 HP roughly.
To estimate the HP you get at any RPM assuming WOT actual-HP-achieved = Max-RPM/7500 X 250. In  a P-PORT rotary max HP is directly proportanal to RPM.

If you are using a ground adjustable pitch prop (highly recommended) keep the diameter below about 72 or 70 inches and you will be able to control the amount of HP you get over a wide range by changing the pitch. That is because prop tip drag is a major part of the HP consumed by a prop.

Paul Lamar

   The Rotary Engine News Letter. Powered by Linux.
   ACRE NL web site. http://www.rotaryeng.net
   You Tube key word PaulLamar2
   Copyright 1998-2012 All world wide rights reserved.