Subject: P-port low rpm performance?
From: rotaryeng
Date: 10/13/2012, 4:19 PM
To: AAAA Put this in the To box




I was reading on an aircraft forum last night that the p-port
   rotary
doesn't make much power below 5000rpm, how accurate is this? if
   so does
this mean economy cruise is difficult to achieve? My airplane
   spec calls
for 160-210hp, so that is about 135hp for cruise. With a p port
   at 250hp
I would have great speed from the extra hp at altitude at WOT
   and i can
just limit manifold pressure in the lower levels to 210hp to
   prevent the
engine departing and taking the firewall with it. Maybe the
   compromise
is with the length of the intake runners? Is it really possible
   to have
the best of both worlds here or do I need a reality check?

Alex

I depends on the intake runner length. Make it 24 inches and that
will move the best BSFC point down the RPM range. You will lose a
bit of power at 7500 RPM but your cruise prop may prevent that max
RPM anyway.
I assume a fixed pitch prop. If you want the best of all worlds use
a variable pitch prop and a trombone intake manifold like the Le
Mans engine had.

Paul Lamar

   On my planning I was leaning towards a fixed pitch prince p-tip, try
   keep it lighter, cheaper,simpler

   Prince claim an effective "increase" in prop diameter with their design
   because of not losing the lift at the tips, they also claim some of the
   benefits of variable pitch, (all on their website) My max prop diameter
   is 74 inches, more diameter and i cut grass, so if the hype makes the
   diameter effectively 76"+ then by my limited understanding with the
   2:85 i can go 72" for more rough field clearance or 74" and enjoy the
   benefits of an effective 76" prop

   Alex

   The diameter and pitch of the prop determines the max HP. If the
   engine can achieve 7500 RPM on take off then you will get 250 HP
   roughly.
   To estimate the HP you get at any RPM assuming WOT
   actual-HP-achieved = Max-RPM/7500 X 250. In  a P-PORT rotary max HP
   is directly proportanal to RPM.

   If you are using a ground adjustable pitch prop (highly recommended)
   keep the diameter below about 72 or 70 inches and you will be able
   to control the amount of HP you get over a wide range by changing
   the pitch. That is because prop tip drag is a major part of the HP
   consumed by a prop.

   Paul Lamar

Paul that makes sense, the smaller diameter is also more practical with
uneven grass fields on a low slung composite. I'll see what ground
adjustable props are available for the rotary.

Alex




The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.