New Subject,
Does anyone have a dimension-ed drawing for a 3:1 reduction box
modeled on Tracy's Box?
Milo
This is what I have so far.
Paul Lamar
I measured mine up for CAD drawings before I assembled it, but with the holidays I haven't had time to draw it. I
will get to it shortly.
Kevin Alderman
Kevin, would appreciate a copy. I think it is time to do a 3:1 drive.
Would like suggestions from one and all on the appropriate gears by part
number if possible. Also design concepts as well, like integration with the
standard bell housings to keep the costs down.
milo
If you build it like this you can use a relatively cheap constant speed
hydraulic prop.
I forget the attachments.
Paul Lamar
I don't think that the modifications for the long nose for the constant
speed prop is necessary. While I had mine apart, I looked at this in
particular. The existing shaft is hollow, and the oil that is introduced
through the main bushing leaves through the shaft. The prop end of the
shaft is sealed with what looks like a freeze plug. The planetary gear is
lubed by the oil that circulates from inside the shaft and then through the
open end where it lubes the planetary set, and through a little slot it ends
up at the needle bearings at the input shaft.
If we could get a spline adapter that could drive the standard aircraft
governor from the accessory drive where the old oil injection pump was (I
think this is a 2:1 drive reduction like the CAS) we could mount it there.
There is already an oil passage inside that lubes the oil pump drive shaft,
and this should do well to lube the spline adapter. The block where we
mount the governor would be fed oil from a line like the turbo or PSRU, and
the oil from the governor would be sent to the PSRU.
The mods would take place inside the PSRU- the shaft is hollow, and needs 1-
a second oil feed, and 2 to block off the inside of the shaft about mid way
to keep the governor pressure on the prop end. Open up thr hole in the end
of the shaft so it will feed the prop, drill a hole in the shaft to let the
oil in, and a hole in the top of the PSRU more toward the prop end of the
unit, and it should work. The forward drain hole is on the forward side of
the existing bushing, this would have to be moved to behind the bushing or
all the oil pressure would pour back in to the oil pan. I think we would
need a seal facing rearward on the rear of the retaining ring to keep the
oil in also. The excess oil from the governor end would pass through the
bushing and return, or we could place a small metered opening where the
existing drain hole is to keep oil circulating and cool. Easy.
Kevin
Alderman
It is long to cut down the oil pressure loss and at the same
time take care of the gyro bending loads.
What you need is a blue tooth oil pressure sender that rotates :)
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.