"Neil Hintz, Autoflight Ltd. We build the new three gear, gearboxes Titan
use now on their V6 engines. This design is based on our Subaru H6 heavy
duty 300 unit with an extra gear in the middle. Shafts are short with
diameters large, input gear has no join and is one piece shaft and gear.
Output shaft has a tapered joint, gear to shaft ( keyed ) with a large
spring type washer under the retaining nut to hold the taper tight through
torsion and temperature changes. Input gear and out gear design have been
in production for approx four years now, only one failure known, on a
Rotamax rotary engine ( 120 hp ). This unit was used with a long driveshaft
of unknown frequency ( we didn't know what was going to happen ).
The three gear units are operating satisfactory here in NZ and at Titan
although I think the highest hour three gear unit has only 100 hour on it so
far. We use a rubber connection from crank to gearbox, I'm not a fan of one
way clutches. Some Autoflight Subaru gearboxes in Australia have nearly
1000 hours on ( 160 HP units ), Oil changes every fifty hours. Double row
angular contact bearings used on both input and output shafts with rollers
opposite to allow for expansion. Gears are EN39B case hardened to 60R,
alloy case is CC601 heat treated to T6, output shaft is 4140. Gears are set
with minimal backlash, 11 degree helix, enough to shut them up. I am happy
to answer questions you may have, if I can."
I was curious about this unit. It has oil fed CS prop provisions. I did not
find a website with more information, but they supply Titan, the p51
kitmaker
Marc
The rubber coupling used is too stiff. It resonates 1800 to 2000 RPM on a
Rotamax just like Tracy's does on a 2 rotor Mazda.
Planetary gear sets are six times stronger than a spur gear set for a given
gear width. Spur gear back lash increases as the gear box warms up. This does
not happen with a planetary gear box. Spur gears were only used on V engines in
WW II to get the thrust line in the middle of the engine or to fire a cannon
through the prop shaft. Otherwise they are a bad idea for an aircraft engine
gear box. There is a huge weight penalty. All radial and gas turbine engines
had/have planetary PSRU's with few exceptions.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.