Subject: dimension-ed drawing for a 3:1 reduction box
From: rotaryeng
Date: 12/30/2012, 4:35 PM
To: AAAA-rotaryeng


New Subject, Does anyone have a dimension-ed drawing for a 3:1 reduction box
modeled on Tracy's Box?

Milo

This is what I have so far.

Paul Lamar

I measured mine up for CAD drawings before I assembled it, but with the
holidays I haven't had time to draw it. I will get to it shortly.

Kevin Alderman

Kevin, would appreciate a copy.  I think it is time to do a 3:1 drive. Would
like suggestions from one and all on the appropriate gears by part number if
possible.  Also design concepts as well, like integration with the standard
bell housings to keep the costs down.

milo

If you build it like this you can use a relatively cheap constant speed
hydraulic prop.

I forget the attachments.

Paul Lamar

I do that also. I thought they were grey hairs overcoming me, but there is
some evidence they may be blonde:-))).

Dale Davies

Paul, Jean Prudhomme has a PSRU similar to your attachment drawn up in Rhino
and made the casting patterns for it. I don't know the current status but
perhaps he will let us know.


george grimes


George, do you know what the part numbers for the bearings and the material
and heat treat for the shaft

Milo


If you copy the Lycoming crank shaft dims you can use the Lycoming shell bearing
and front stretch over oil seal.

That is what I would do. It is a proven design. Some times you can make the
smallest of changes in a design and run into all sorts of unforeseen problems.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.