Subject: Penetrating Oil-equivalency, vs home made
From: rotaryeng
Date: 1/6/2013, 9:40 PM
To: AAAA-rotaryeng


Interesting—

Marc

-------------------------------------------------

Subject: Penetrating Oil

"Machinist's Workshop" recently published information on various
penetrating
oils.  The magazine reports they tested these products for "break out
torque" on rusted nuts and bolts.  A subjective test was made of popular
penetrating oils, with the unit of measurement being the torque
required to
remove the nut from a "scientifically rusted" bolt.


Average torque load to loosen nut:

No Oil used .........................516 foot pounds

WD-40 ...............................238 foot pounds

PB Blaster ..........................214 foot pounds

Liquid Wrench .......................127 foot pounds

Kano Kroil ..........................106 foot pounds

*ATF/Acetone mix .....................53 foot pounds*

*The ATF/Acetone mix is a "home brew" mix of 50/50 automatic
transmission fluid and acetone.


Note this "home brew" released bolts better than any commercial
product in
this one particular test.  Our local machinist group mixed up a batch,
and
we all now use it with equally good results.  Note also that Liquid
Wrench
is almost as good as Kroil for about 20% of the price.

ATF/Acetone mix is best, but you can also use ATF and lacquer thinner
in a
50/50 mix.


ATF = Automatic Transmission Fluid

Please tell us which ATF was used. There are various specifications. Has
anyone tried this as a tapping compound or a cutting oil?

Al Rees