Subject: can a Lycoming 540 engine be used in, the pusher con configuration
From: rotaryeng
Date: 1/9/2013, 8:57 AM
To: AAAA-rotaryeng


  Paul, a quick question, can a Lycoming 540 engine be used in
the pusher con configuration? Are the thrust rings on the
    crankshaft the same thickness?
Milo


  Yes they can be used but you need to provide a needle thrust bearings
  behind the planet carrier. See the attached 3D.
   Needle bearings hate big diameters and high RPM so use at least
  two back to back or three to cut the RPM and on any one of them.
   The thrust rings on the  crankshaft are irrelevant.
   Paul Lamar


  Paul,
 Have located an I0 540 crankshaft. Will ship directly
to you for measurements for sand casting drawing. When we pour
if anyone else would like a casting let me know, 6061-T6. Thanks, Milo



OK

Paul Lamar


Forgot, Paul please keep in mind we would like to install a pressure
ring so that we may measure thrust, accommodations for pusher loads,
and fit to auto transmission bell housing.

Thanks again. milo

No problem It will have both so it can be used with Jeff motor
mount plate as well.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2013 All world wide rights reserved.