Paul,
Is it feasible to use a solid case, instead of a split case using inside
snap rings to separate the rotating elements?
milo
In theory yes because the rear flange is bolted on.
But given what I little I know about overhauling
piston engines bearing shells halves are a bit over size so when you torque
the case bolts... the shells compressed slightly and are held securely in place.
All you piston engine guys out there chime in on this.
The other problem is the oil slinger near the front of the shaft
but there is a work around for that.
Paul Lamar
----------------------------------------------
Forgive me for my lack of attention to this, but is someone planning on
fabricating a kit or an entire psru that will provide oil pressure to a CS
hub? If so, are there any plans on a governor, and what are they? I would
be interested in a CS psru, seems Mistral is gone to never never land......I
don't think anyone makes one, that outfit in Canada with the spur gear drive
did for some time, but seems to have faded.....
Marc W
Yes. That is what Milo is up to :)
You will have to drive the gov with a cog belt off the nose
of the e-shaft.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2013 All world wide rights reserved.