Subject: 3.17 drive-oil fed CS provisions
From: rotaryeng
Date: 1/13/2013, 8:29 AM
To: AAAA-rotaryeng



Paul,

Is it feasible to use a solid case, instead of a split case using inside
snap rings to separate the rotating elements?

milo

In theory yes because the rear flange is bolted on.

But given what I little I know about overhauling
piston engines bearing shells halves are a bit over size so when you torque
the case bolts... the shells compressed slightly and  are held securely
in place.

All you piston engine guys out there chime in on this.



The other problem is the oil slinger near the front of the shaft
but there is a work around for that.

Paul Lamar

------------------------------__----------------

Forgive me for my lack of attention to this, but is someone planning on
fabricating a kit or an entire psru that will provide oil pressure to a CS
hub?  If so, are there any plans on a governor, and what are they?  I would
be interested in a CS psru, seems Mistral is gone to never never
land......I
don't think anyone makes one, that outfit in Canada with the spur gear
drive
did for some time, but seems to have faded.....

Marc W

Yes. That is what Milo is up to :)
You will have to drive the gov with a cog belt off the nose
of the e-shaft.

Paul Lamar


    I don't think anyone would recommend trying to use split bearings in a
    non-split mount as the bearing relies on crush to hold it in place.  There
    may be a one piece bearing, like are used on camshafts, that would work.

    Gary

The governors that was used on my continental IO520D was spline drive
through a gear off of the crankshaft at the forward end of the engine.  I
will check on it, but not be surprised if this wasn't reduced from engine
rpm.  I dont see a problem with the governor running at a higher speed than
the prop, since it is responding to its input rpm by making adjustments to
the prop pitch.

Kevin Alderman

The wimpy  Mazda gears would never take the torque load.
It is not an injection pump. It is an oil metering device.
The oil is drawn into the intake chamber by an air pressure diff.

The gov has a high pressure oil pump in it.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2013 All world wide rights reserved.