Subject: universal composite airplane rotary motor mount.
From: rotaryeng
Date: 1/13/2013, 9:46 AM
To: AAAA-rotaryeng


 This is for Alex's Tango but it will work on most tractor
 composite air craft.

 It meets the requirements of Industrial Metal Supply in
 San Fernando California for laser cut one inch tubes and optional
 welding. Some of the parts should be made by your local welder
 to cut the cost. IMS is expensive and laser cutting is not required
 for most of the small parts. I have the forward cups in stock
 at low cost. See the web site.

 One offs are expensive so a group buy would be cheaper.

 Paul Lamar

Hey Paul,

I'm sure I'm missing something here.  I don't see how the engine is
going to be attached to this device.  I see two points at the fan end,
labeled "Welding cups supplied in stock 2", that appear to be places to
attach the engine.  Those would do a great job of securing the engine in
the roll axis but I don't see where there is any provision for securing
the engine in the pitch axis.

 Mark LaPierre


Here is the engine installed.
It should look familiar :)


Paul Lamar