My injectors (the ones that I have at the moment) are the tan top 550cc low
impedance units. The research that I did over the past couple of days
concerning these specific injectors is that they are peak and hold, require
4 amps to open and 1 amp to hold. A 1 amp current will not open them fast
enough, and 4 amps continuous will kill them. The LM1949 is specifically
designed to take the VCC and after triggering the injector to fire send the
peak 4A then the 1A hold until the PW is gone and then start over. I don't
see how the monostable or even an astable single 555 will accomplish this in
itself. It may be possible to have 2 555 chips fire in sequence, but with a
requirement of 4 amps. The LM1949 was only about $3 and needs one for each
injector. My board will output directly to this driver from its digital
output pin making it a very simple system. Not taking any shortcuts, but
not going overboard either.
I would assume that you could drive it from the 555 simple system output as
well, but I have reservations about being
able to drive the injectors without the driver board.
Also, megasquirt has a board kit for 58$ that includes everything needed to
drive 4 injectors. Cheap enough.
There is a lot of information around about switching injectors on cars and
how the peak and hold are so different from
the saturated ones. I have 6 of the same peak and hold ones, so I will start
with the driver board and go from there.
Kevin Alderman
Here is the latest list of injectors.
http://users.erols.com/srweiss/tableifc.htm
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2013 All world wide rights reserved.