Subject: gear driven electric motors
From: rotaryeng
Date: 1/14/2013, 6:29 PM
To: AAAA-rotaryeng


 I found these today and have ordered one for the flap actuator in my
plane.
 http://www.pololu.com/catalog/category/116

 I ordered the adapters for the end and will couple this motor to a fine
 thread 5/16 rod, with a corresponding threaded "nut" on the flap torque
 tube. Total cost- about 45.00. And, this unit has an output that can be
 read by the computer, stopping the flaps wherever I set them to stop with
no
 additional moving parts. When it gets here and I get it put together, I
 will take a pic of it. I have the cheap small boards that will work
 perfectly to make it go. And in my usual fashion, it will work without
the
 computer just by holding the button down.

 How about a fully automatic flap actuator for about $75.00?


 Kevin Alderman

We used these motors to drive robots built for last year's mechatronics
competition. They seem competent. We used the
custom driver shield for Arduino Mega:
http://www.pololu.com/catalog/product/2502

Chris Cosman

A shameless plug...


Try www.roboticsautonomous.com for gearmotors.  Prices are slightly less
than pololu.

http://www.roboticsautonomous.com/gear-motors/gearmotor-67-1-metal-37dx54lmm-straight-shaft/

Rick Irwin


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube key word PaulLamar2
Copyright 1998-2013 All world wide rights reserved.