Alex, with a few changes to the water pump
and intake plenum I can use a simple top mount
and simplify the main motor mount greatly.
You will need to add a hard point to the top of the
firewall at the center. This is a real old idea used
by Power Sport 20 years ago.
Paul Lamar
Here is what the low cost version of the Tango mount with the
top motor mount. Fewer laser cut tubes and welded joints.
Rotary installation is driven by cost.
I had an idea on how to mod an off the shelf car shock
and convert it to an air spring.
Drill a hole and drain the oil. Tig weld or braze a pipe
fitting on. refill with oil and plumb to an air pressure
can.
Paul Lamar
Here is what we are looking for.
With an inch and a half piston with 100 psi we have
a static force of 176 pounds. Cut the piston rod to three inches
and use a threading die to thread the rod for a female rod end.
Use a stock rubber bumper.
Patent applied for :)
Paul Lamar
Hi Paul the shock idea sounds like a great idea, it would be rigid in the
lateral movement plane where the current RV gear sets itself up a shimmy
when ever the nose gear is not set down dead straight. Regarding the low
cost MM idea I am all in, I don't have an eye for gauging structures so I'm
happy with what your best feelings are on it. I can glass in the top mm
hardpoint when I tip the plane on its nose to do bodywork on the sides and
underneath, that shouldn't be a problem :-)
For the water pump I thought Milo already had a smaller setup there, what
would be the mods on that, blank it off and
make it a remote system?
Alex
Because of the mechanical advantage you will have to find one from a sport
Ute or pick up. Gas pressure alone may not do the job. If that is not enough
you may have to add a die spring. It should just support the nose with no
deflection. Only when impacting the ground should it deflect.
What is the estimated static weight on the nose gear?
Send me some pictures of the water pump you have.
Is it stock RX8? If so move the slide throttle out a bit to get
clearance for water going in and coming out. We have one or two
blocks left for that purpose.
If Tango offered a motor mount, rad ducting and cowl for the rotary
they would sell more airplanes because of the lower cost.
That would save the builder a lot of time.
Paul Lamar
-- The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.