Subject: Tango motor mount redesign for lower cost
From: rotaryeng
Date: 1/21/2013, 1:24 PM
To: AAAA-rotaryeng



 Alex, with a few changes to the water pump
 and intake plenum I can use a simple top mount
 and simplify the main motor mount greatly.

 You will need to add a hard point to the top of the
 firewall at the center. This is a real old idea used
 by Power Sport 20 years ago.

 Paul Lamar

 Here is what the low cost version of the Tango mount with the
 top motor mount. Fewer laser cut tubes and welded joints.
 Rotary installation is driven by cost.

 I had an idea on how to mod an off the shelf car shock
 and convert it to an air spring.

 Drill a hole and drain the oil. Tig weld or braze a pipe
 fitting on. refill with oil and plumb to an air pressure
 can.

 Paul Lamar

 You can buy shocks that way now. Takes the fun out of when the shock
 will blow up when the oil vapourizes from the heat.

 Dale Davies

 Got any specific car model suggestions Dale.
 Preferably something heavy like a sport ute or pickup truck.

 Got any junk ones lying around I can play with and test.
 I'll pay shipping. I need mono tubes.

 Paul Lamar

  Here are some pics, unfortunately i am not in the USA at the
 moment to take more pics but the one pic shows the water pump outlet
 mods Milo did, its not a slide throttle on this one, the intake
 plenum is on the side of the intake so it should be easier to attach
 the top supporting strut to the top of the engine and the top centre
 of the firewall, i'd like to turn the intake around and have it
 facing relative airflow rather than the firewall, net me a bit of
 ram air pressure, I'd also like to look at p-porting as a project
 for later down the line once she's flying and proven, but i guess i could
 route the pipes around the top MM strut somehow,

  Alex

 Ah so stock RX8 water pump.
 P-port and slide throttle.
 If so you will need an WP adapter block.

 Paul Lamar


 What you want is "remote reservoir shocks" for off road apps. I give the site
    for Bilstein only. Search off road shocks and other manufacturers will be listed.
    http://www.4wheelparts.com/__parts/bilstein/shocks.aspx <http://www.4wheelparts.com/parts/bilstein/shocks.aspx
    Off road should give the weight capacity you are looking for and you should be
    able to vary the air or gas charge in the reservoir for tuning.

    Dale Davies


 Paul, the average tango nose wheel weight is 289lbs,
 Alex


 OK Alex. Thanks. That means we will need about 900 pounds
 on the shock strut. Looks like time for an aux die spring.

 Paul Lamar

Just to be helpful...  We used a spring from a  mountain-bike rear
 suspension for our nosewheel install.

Chris Cosman

Nice work Chris. What damps it? :)

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.